Skorpion 250 R is designed for shredding tree limbs and trunks with a diameter of up to 250 mm. Skorpion 250R is a disc model with a pneumatic blow-out system on the disc. Chips are ejected through the rotating chimney which can turn by 360 degrees in relation to the chassis. The cutting system consists of a disc with cutting knives sharpened on either side.
The chipper has a three-point suspension system and is designed to work with an above 80 hp farm tractor. The drive is transmitted from PTO shaft of a tractor with the speed of 540 revolutions per minute.
Its feed system consists of two pulling rollers, driven by separate hydraulic motors from a hydraulic pump mounted on the chipper.
Safety of the operator of a chipper is ensured by a cable safety switch attached, which - by pulling the cord in any direction - causes the hydraulic feed system to stop immediately. Unlocking the system takes place by releasing / unlocking the EMERGENCY STOP button to the work position.
The wood chipper equipped with an electronic No-stress system that automatically prevents overloading of the drive system by temporarily stopping the feed system. Editing the No-stress overload system allows you to easily change the machine settings and adjust them to individual needs. The program "thick wood", "thin wood" allows a quick change of the working mode of the chipper to suit the currently shredded material and more effective work of the wood chipper. This system has a built-in hourly meter.
Chips made by Skorpion 250 R can be used as a solid fuel for heating in buildings (burning in ovens/stoves), as raw material to produce compost, for decorative purposes in gardens, parks, etc., and after additional disintegrating in a mill for production of pellets and briquettes.
SKORPION 250 R
|Overall dimensions (length x width x height) [mm]||2500 x 2030 x 2560|
|Branch diameter [mm]||250|
|No of knives||2 or 3 cutting + 2 counter-knife|
|Feeding speed [running meters/min]||up to 42|
|Chipping capacity [stère meters/h]||up to 18|
|Chip width [mm]||from 9 to 14|
|Feeding unit||hydraulic feeder|
|Disk diameter [mm]||800|
|Hopper dimensions (width x height) [mm]||420 x 255|
|Type of drive||tractor’s PTO|
|Min. power of tractor [hp]||80|
Additional accessories on request: